High Pressure TurboDrop® NOZZLE:
• Drift control pressure range is 30-90 PSI. Targeting 60-70 psi operating pressure will allow for greater changes in speed and pressure. Max pressure is 150 psi.

• Between 30 and 80 psi, the spray angle of the exit tip will narrow by approximately 10-15% (making a 110° degree tip essentially a 90-100° tip). Make necessary boom heighth adjustment for desired overlap. (For 20" spacing, a height of 24-40" is recommended.)

• Higher pressures are recommended for penetration into a dense crop canopy and for better coverage with contact chemicals.


High Pressure TurboDrop® VENTURI:
• The venturi must be correctly matched to the exit tip. The venturi controls the flow rate; the exit tip determines the pattern only.

• Flat fan, flood, twin jet, hollowcone tips and others may be used with the venturi. Droplet size will vary with type of exit tip used. (Please consult Greenleaf.)

• Extended Range tips are not recommended for pressures over 60psi.

• Always test any combination that you intend to use.

	TurboDrop® Venturi	Exit Nozzles
		Flat Fan	Flood	Hollow Cone
	TDVC01 (orange)	-- 03 (blue)	1.5	QHC-023
	TDVC015 (green)	-- 04 (red)	2.0	QHC-045
	TDVC02 (yellow)	-- 05 (brown)	2.5	QHC-045
	TDVC025 (purple)	-- 06 (gray)	3.0	QHC-068
	TDVC03 (blue)	-- 06 (gray)	4.0	QHC-068
	TDVC04 (red)	-- 10 (black)	5.0	QHC-068
	TDVC05 (brown)	-- 15	7.5
	TDVC06 (gray)	-- 15	7.5
	TDVC08 (white)	-- 20	10
	TDVC10 (black)	-- 20	10.0